Splitter and Airdam

Why Plywood ? Well as I`ve said before, it`s cheap, easy to form and does the job. A friend commented that the McLaren 650s GT3 championship winning race car uses […]

Read More »

Engine Build

Before we went to Mexico, I posted a `wanted` thread on ClubGTi for a replacement engine. I NEEDED a new block, pistons and crank. I already have all the other […]

Read More »

Oulton Park November 2015

Crap drive over on the M62, traffic was particularly bad, added another 30 minutes to a 90 minute drive, but arrived, signed on and unloaded the Golf. Steve didn`t have […]

Read More »

Manifold Repair 2015.

Post Anglesey Manifold failure & repair I had a failure on my manifold, appears to be along the Fusion line. The penetration was good, might not look it from the […]

Read More »

Croft. July 2015

A bit of a last minute rush to get it finished, but it was loaded up onto the trailer around 6pm on Sunday evening. Funny, reading back that one sentence […]

Read More »

Rollcage and Interior

The screen has had a stone chip caused crack for a while and it`s getting bigger, so I used the opportunity to remove the screen, sort the A pillar gussets […]

Read More »

Anglesey June 2015

After a lot of work that 99% of people will never even see, never mind notice, it was pleasing to get some cosmetic work finished and the car looked much […]

Read More »

Bedford. March 2015

Had a steady drive down to Bedford on Sunday afternoon. Sat behind a lorry for over 100 miles at 56mph. Averaged 28.2mpg. We weren`t in a rush so it didn`t […]

Read More »